High End Systems Roadster Orbital Head System User Manual download pdf (Page 20)

CHAPTER 2

Setup and Configuration

10 Roadster Orbital Head System User Manual

3. Remove the three existing

projector M10 x 20mm hex bolts

and lock washers (B).

4. Retract projector foot (C) to

minimum height to accommodate

the bracket.

5. Slide the bracket over the

projector.

6. Insert the three provided spacers

(D) between the bracket and the

projector

7. Reinstall the three hex bolts and

washers (B) through the spacers.

8. If you are not using the lifter eyes

on the projector for truss mounting,

install the optional M12 x 35mm

hex bolt, lock washer and flat

washer (F) provided to secure the

bracket to the projector.

Mounting the Power Hub

Attach one or two cheeseborough

clamps to the mounting bracket for

mounting on any standard truss. Use

safety cable to secure the Power Hub to

an independent support.

Note: The Power Hub must be located

within two meters of the

projector head for correct

performance.

Mounting bracket

Locking washer

Flat washer

Locking

Flat

washer

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 53 54

No comments

High End Systems Roadster Orbital Head System User Manual Page 20