High-end-systems DL.3 User Manual download pdf (Page 32)

CHAPTER 2

Setup and Configuration

10 DL.3 Digital Light User Manual

3. Tighten the clamps firmly to the fixture’s base

and to the support.

4. Run the safety cable through the loop on the

fixture’s base, and around the truss.

Note: High End Systems does not recommend

operating the DL.3 fixture with the base

perpendicular to the stage floor (fixture

mounted sideways). Side mounting will

result in significantly decreased lamp

life.

Linking DL.3 Fixtures

DL.3 fixtures should be linked to a standard DMX512 link for control by a DMX desk as well as a

Ethernet fixture link for CMA functions.

Setting up a Standard DMX Link

The number of fixtures on a link will be determined by the combined number of channels

required by all the fixtures. The DMX channel range of a DL.3 fixture is determined by the

protocol mode you choose.

• DL.3 Standard Protocol = 170 channels

• DL.3 Dual Protocol = 132 channels

• Single Protocol = 94 channels

Use data-grade cable and 5-pin XLR cable connectors. For cable and connector specification, see

“Cables and Connectors” on page D-305.

Test each cable with a voltage/ohm meter (VOM) to verify correct polarity and to make sure that

the negative and positive pins are not grounded or shorted to the shield or to each other.

CAUTION!

Do not connect anything to the ground lug on the XLR connectors.

Do not connect or allow contact between the common (cable shield)

and the fixture’s chassis ground. Grounding the common could cause

a ground loop and/or erratic behavior.

To link one or more fixtures to a DMX controller:

1. Connect the male XLR connector of a DMX Data cable to the controller’s DMX Data Out

connector.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 333 334

No comments

High-end-systems DL.3 User Manual Page 32