High End Systems DL1 User Manual download pdf (Page 26)

2-6 Setup and Configuration DL.1 User Manual

Mounting Procedure

1. Disconnect power to the fixture. If it has been operating, allow the fixture to cool

for five minutes before handling.

2. At least two people are required to mount the fixture with one person on each

side supporting and attaching that side of the fixture. After the clamps are

attached, one person can support the fixture while the other attaches safety

cables.

3. Optionally lock the pan and tilt positions as discussed in “Pan and Tilt Locks” on

page 2-12.

4. Attach two mounting brackets to the base of the fixture (as shown in Figure 2-3)

using the provided quarter-turn screws.

5. Attach suitable cheeseborough clamps to the

mounting bracket. Use locking washers when

attaching the clamps to the fixture’s base.

6. Tighten the clamps firmly to the fixture’s base and

to the support.

7. Loop one or more suitable safety cables around the

support, around the fixture’s base, and around the

truss. Figure 2-4 shows an example:

Figure 2-3 Attaching the Mounting brackets

Attach

one

mountin

bracket

Loop safety cables through

holes in base

Attach

one

mounting

bracket

Figure 2-4 Truss Mounting

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 81 82

No comments

High End Systems DL1 User Manual Page 26