High End Systems High End LCD Controller for Studio Color User Manual download pdf (Page 174)

7-12

RAM Card: Write-Protection

Studio Color LCD Controller

RAM Card: Write-Protection

After backing up either the operating system or memory to

the RAM card, you should write-protect that card to prevent

it from being inadvertently erased.

Examine the end of your RAM card to locate the small write-

protect tab. Also note the battery release, typically located

near the battery compartment. Do not disengage the battery

release, since that could cause the battery to fall out of the

RAM card.

Note Figure 7-1 below shows the RAM card shipped with

the Studio Color LCD controller (part number

80440017). Because of the wide variety of

compatible RAM cards available, you should consult

the documentation provided with your RAM card if

you are unsure of the location of its components.

Figure 7-1 shows the locations of the write-protect tab and

the battery release on the RAM card that is being shipped

with the Studio Color LCD controller at the time of this

writing:

Figure 7-1. Slide the write-protect bar to the right to

allow the RAM card to accept data, or move it to the

left to prevent it from accepting data.

MEMORY CARD

Not protectedWrite-protected

(locked)

Battery compartment

Battery release

Write protect

tab

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 271 272

No comments

High End Systems High End LCD Controller for Studio Color User Manual Page 174