High End Systems High End LCD Controller for Studio Color User Manual download pdf (Page 106)

4-22

Preset Programming

Studio Color LCD Controller

Recording a Loop as a Preset

Start the loop running, then assign the entire loop to one of

the Preset keys. For more information about loops, see the

section titled “Creating a Loop” on page 4-14.

1. Use the Page

<Up>

and

<Down>

arrow keys to select any page

within the loop that you want to record as a preset.

2. Toggle the

key until the Address LED is

ON.

3. Press the

<Auto>

key. The pages start advancing, playing

back the loop at the rate set by the

<Rate>

knob and the Delay

construct.

4. Toggle the

key until the Preset LED is

ON. The LCD display then appears as shown below:

5. Use the Cursor

<Right>

and

<Left>

arrow keys to select a bank

of presets. Each bank contains 8 presets.

6. Press the

key. The Select LED flashes and the LCD

display appears as shown below:

7. Press the Preset key (

<1>

<8>

) on the front panel to store

the loop. See Figure 4-5 on page 4-20 for an explanation of

how preset bank numbering works.

8. Optional. If you are using 12-level preset access, follow the

instructions in the section titled “Using Twelve-Level Preset

Access” on page 6-19.

9. Adjust the following settings; these settings are recorded as

part of the preset (you can change them later).

PRESET

ADDRESS

PRESET

ADDRESS

7#88  #+  -*#+

&,?#++@"

;)    *  3- <

;0:'

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 271 272

Comments to this Manuals

No comments

High End Systems High End LCD Controller for Studio Color User Manual Page 106

Comments to this Manuals

Related products and manuals for Supplementary music equipment High End Systems High End LCD Controller for Studio Color