High End Systems High End LCD Controller for Studio Color User Manual download pdf (Page 157)

Studio Color LCD Controller

Audio Input Playback

6-27

Audio Input Playback

You can use an external stereo source to control playback

through any or all four playback modes listed below. Audio

input playback affects how initialized pages play back,

regardless of whether those pages are part of a loop or not.

To enable audio input playback, plug your stereo source into

the Stereo Audio Input connector on the controller’s rear

panel as shown in the section titled “Other Connectors” on

page 2-23.

Also see the section titled “Random Advance” on page 6-29.

• Audio 1 advance (User 3 key): Pages advance with the

amplitude of the audio signal.

• Audio 2 advance (User 5 key): Page advance pauses

with the amplitude of the audio signal.

• Color modulate (User 2 key): Cycles through the six

positions on the color wheels of all active fixtures with

the beat of the audio signal, overriding the Color

construct settings.

• Dim modulate (User 6 key): Light intensity of all active

fixtures changes with the amplitude of the audio signal.

You can adjust how much the dim varies (from full dim

to full bright, or a small dim change resulting in a

“flickering” effect) using the

<Audio>

knob, as shown in

Figure 6-4:

Figure 6-4. Adjusting the sensitivity of the dim

modulate effect to the audio signal.

audio

dim varies the least

(fixtures stay at about

full intensity)

dim varies the most

(fixtures go from

full dark to full

bright)

level

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 271 272

No comments

High End Systems High End LCD Controller for Studio Color User Manual Page 157